Which mac address will receive the arp reply chapter exam answer

3. Refer to the exhibit. A network administrator has configured R1 as shown. When the administrator checks the status of the serial interface, the interface is shown as being administratively down. What additional command must be entered on the serial interface of R1 to bring the interface up?

4. What is one feature that distinguishes routers from Layer 2 switches?

5. Which command is used to configure an IPv6 address on a router interface so that the router will combine a manually specified network prefix with an automatically generated interface identifier?

7. What two pieces of information are displayed in the output of the show ip interface brief command? (Choose two.)

9. Refer to the exhibit. PC1 attempts to connect to File_server1 and sends an ARP request to obtain a destination MAC address. Which MAC address will PC1 receive in the ARP reply?

10. A packet moves from a host on one network to a device on a remote network within the same company. If NAT is not performed on the packet, which two items remain unchanged during the transfer of the packet from source to destination? (Choose two.)

12. Which two items are used by a host device when performing an ANDing operation to determine if a destination address is on the same local network?

(Choose two.)

CCNA 2 Chapter 4 Exam Answer 003 (v5.02, 2015)

CCNA 2 Chapter 4 Exam Answer 004 (v5.02, 2015)

CCNA 2 Chapter 4 Exam Answer 005 (v5.02, 2015)

17. A network administrator configures the interface fa0/0 on the router R1 with the command ip address 172.16.1.254 255.255.255.0. However, when the administrator issues the command show ip route, the routing table does not show the directly connected network. What is the possible cause of the problem?

21. Refer to the exhibit. What is the purpose of the highlighted field in the line that is displayed from the show ip route command?

CCNA 2 Chapter 4 Exam Answer 008 (v5.02, 2015)