The load resistor ohm

Simetrix Circuit Analysis Guide- Simetrix (Homework)

Your question:

1. • Open SIMETRIX and create a new project.

   • Draw a single-phase bridge rectifier circuit with a 44-ohm load resistor connected to a 220 V 50 Hz supply. The bridge rectifier should consist of diodes and capacitors as needed.
2. • • Input Voltage: Place a voltage probe across the input terminals of the bridge rectifier to measure the AC input voltage waveform.

     • Output Voltage: Place a voltage probe across the terminals of the load resistor to measure the DC output voltage waveform.

4. View and Analyze Results:

   • After the simulation is complete, you can view the input and output voltage waveforms on the oscilloscope-like display in SIMETRIX.
5. • • Vrms_output is the RMS voltage across the load resistor.

     • Rload is the load resistor value (44 ohms).

Where:

• Vout_rms is the RMS voltage across the load resistor (198 V).